Using Lanview; C2G170-24 Lanview Leds - Enterasys SecureStack C2 C2G170-24 Hardware Installation Manual

Using LANVIEW

Using LANVIEW
The switch supports the Enterasys Networks built‐in LANVIEW LED visual diagnostic
and status monitoring system. The location of each C2G170‐24 LANVIEW LED is shown
in Figure
switch and network problems.
Figure 4-1
1 CPU LED
2 Stack down LED
3 Stack up LED
Table
appropriate.
4-2 Troubleshooting
4‐1. The LEDs enable you to quickly observe network status for diagnosing

C2G170-24 LANVIEW LEDs

Å
À
4‐2 describes the LED indications and provides recommended actions as
Note: The terms flashing, blinking, and solid used in
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
Ä
Ã
Â
Á
4 RPS LED for redundant power-source status
5 Manager LED
6 link/activity LED for mini-gbic slot, port 1 of 24 ports
Table 4-2 indicate the following: