Using Lanview; Lanview Leds - Enterasys Matrix E1 1G694-13 Installation Manual

Using LANVIEW

4.1 USING LANVIEW
The 1G694-13 switch uses the Enterasys Networks built-in visual diagnostic and status monitoring
system called LANVIEW. The LANVIEW LEDs
network status for diagnosing network problems.
Figure 4-1 LANVIEW LEDs
➀
PWR LED
➁
CPU LED
Table 4-1 describes the LED indications and the associated recommended actions.
NOTE: The terms flashing, blinking, and solid used in
Flashing: LED is flashing randomly.
Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).
Solid: LED is on steady and not pulsing.
4-2 Troubleshooting
(Figure 4-1) allow you to quickly observe
À
Á
➂
Port RX LED
➃
Port TX LED
Â
Ã
Table 4-1 indicate the following: