Using Lanview; Lanview Leds Of C2G124-24 And C2G124-48 (C2G124-24 Shown) - Enterasys SecureStack C2 C2G124-24 Hardware Installation Manual

Using LANVIEW

These switches support the Enterasys Networks built‐in LANVIEW LED visual diagnostic
and status monitoring system. The LANVIEW LEDs on both the C2G124‐24 and
C2G124‐48 are located in similar locations as shown on C2G124‐24 in Figure
LANVIEW LEDs on the C2H124‐48 are shown in Figure
quickly observe network status for diagnosing switch and network problems.
Figure 4-1
1 CPU LED
2 STACK DOWN LED
3 STACK UP LED
4 RPS LED for redundant power-source status
5 Manager LED
6 Link/Activity LED for
• C2G124-24/C2G124-48:
• C2H124-48: 10/100/1000 Mbps, RJ45
1. These Mini-GBIC ports will only establish a link when the RJ45 port equivalent is not linked on a
4-2 Troubleshooting

LANVIEW LEDs of C2G124-24 and C2G124-48 (C2G124-24 shown)

Å
Ä
Ã
Â
Á
À
10/100/1000 Mbps, RJ45 port 1
port 1
C2G124-24 or C2G124-48. (For example; when Mini-GBIC port 45 is linked, RJ45 port 45 is
deactivated. When Mini-GBIC is not linked, the RJ45 port 45 is reactivated and can establish a link
as long as the Mini-GBIC port 45 is not linked first.)
4‐2. These LEDs allow you to
Æ Ç
7 Link/Activity LEDs for 10/100/1000 Mbps for
• C2G124-24: RJ45 ports 21 through 24
• C2G124-48: RJ45 ports 45 through 48
8 Link/Activity LEDs for 1-Gbps Mini-GBIC for
• C2G124-24: ports 21 through 24
• C2G124-48: ports 45 through 48
4‐1. The
1
1