Table of Contents
Advertisement
Unpacking the Device
3.2
UNPACKING THE DEVICE
Unpack the device as follows:
1. Open the box and remove the packing material protecting the device.
2. Verify the contents of the carton as listed in
Table 3-1 Contents of Shipping Carton
Item
C1H124-48 or C1G124-24
Antistatic Wrist Strap
Console Cable Kit
Rackmount Kit
Manual Accessory Kit
Power Cord
RJ45-to-DB9 female adapter
3. Remove the tape seal on the non-conductive bag to remove the device.
4. Perform a visual inspection of the device for any signs of physical damage. Contact Enterasys
Networks if there are any signs of damage. Refer to
3.3
INSTALLING OPTIONAL MINI-GBICs
This section describes how to install a Mini-GBIC into the front panel Mini-GBIC slots of either
the C1H124-48 or C1G124-24.
WARNING: Mini-GBICs use Class 1 lasers. Do not use optical instruments to view the
laser output. The use of optical instruments to view laser output increases eye hazard.
When viewing the output optical port, power must be removed from the network adapter.
CAUTION: Carefully follow the instructions in this manual to avoid damaging the
Mini-GBIC and the host device (C1H124-48 or C1G124-24).
The Mini-GBIC and host device are sensitive to static discharges. Use an antistatic wrist
strap and observe all static precautions during this procedure. Failure to do so could
result in damaging the Mini-GBIC or host device. Always leave the Mini-GBIC in the
antistatic bag or an equivalent antistatic container when not installed.
3-2
Hardware Installation
Table
3-1.
Quantity
1
1
1
1
1
1
1
Section 1.12
for details.
Advertisement
Table of Contents
Troubleshooting
