Controls And Indicators - C-TEC CAST XFP Engineering Manual

CAST XFP 32 ZONE ANALOGUE ADDRESSABLE FIRE ALARM PANEL

CONTROLS AND INDICATORS

Front panel layout
menu
escape
control panel investigate
reset
Fire Alarm Control Panel Instructions
176b
XFP
EN54-2 & 4
Manufactured in England
LED Indicators
Liquid Crystal Display
(General) Fire
Fire Zones (1-32)
Supply Present
Test
Accessed
General Disablement
Phased Evacuation
ENGINEERING MANUAL • Approved Document No. DFU5010020 Rev 4 • Page 15 of 48
10:59:03 24 Jun
FOXCO WAREHOUSING
more information
Fire
silence
1
internal
sounder
17
accept
supply
present
general
silence/resound
sounders
General fault
flashing light - call engineer
Provides detailed information on the status of the system (the type of messages
displayed and what they mean is covered in greater detail in the panel's
separate user manual).
Flashes red when there is a fire condition on any zone and goes steady red
when the alarm is silenced. Subsequent fire conditions will restart the (General)
Fire indicator flashing until it is silenced again.
One or more of these indicators will flash red in a zone alarm condition and
will go steady when silenced.
Normally lit green to show that all of the panel's power supplies are
functioning correctly.
Lit yellow when the panel is in walk test mode. This LED does NOT illuminate
for any other test condition.
Lit yellow when the panel is in access levels 2 or 3.
Lit yellow when one or more zones, sounders, outputs, relays, devices, output
delays are disabled.
Flashes yellow when there is a phased evacuation in progress.
: Normal
Fire Zones
2 3 4 5 6 7
18 19 20 21 22 23
test accessed
system
power supply
fault fault fault
To view more events use the scroll
I
To silence the internal sounder: press
To silence/resound the alarm sounders: Turn key to l and press
OR press
O
To reset the panel: Ensure all alarm conditions are silenced
and investigations are complete and press
To exit access mode: Remove key
OR press and hold
8 9 10 11 12 13
24 25 26 27 28 29
general
disablement
sounder
status
buttons
and . Enter code and press
14 15 16
30 31 32
phased
evacuation
delays
running
The system must be tested regularly.
If in doubt, refer to the user manual.