Table of Contents
Advertisement
Title TransVu 3 DVR Installation Manual
GPS Page
The GPS page is used to configure the interface of the unit with an external GPS receiver.
Sync time on startup: When enabled, the clock of the TransVu will be synchronised to the GPS time
when the TransVu starts up.
Sync tine periodically: Sets the time interval on which the TransVu clock will be synchronised to the
GPS clock. If set to "Never" the TransVu clock will not be synchronised to the GPS clock.
Sync time on shutdown: When enabled, the clock of the TransVu will be synchronised to the GPS
time when the TransVu shuts down.
Timeout after startup: The timeout interval of the GPS interface, in seconds, after TransVu start up.
GPS String Logging: Allows the selection of the format of NMEA messages produced by the GPS
module.
Multicast IP Address: Allow servers to receive multicast GPS data.
Display Speed Format: Selects the format of speed information captured by TransVu from GPS
data. The available options are:
Knots
•
Miles per hour
•
Kilometres per hour.
•
Accelerometer Page
The accelerometer page is used to configure the operation of the on-board accelerometer.
NetVu Ltd. www.netvu.org.uk
No 1 Thellow Heath Park, Northwich Road, Northwich, Cheshire. CW9 6JB
Page 35 of 66.
Advertisement
Table of Contents
