Table of Contents
Advertisement
Title TransVu 3 DVR Installation Manual
12V Output: Enables or disables the auxiliary 12 Volt supply output of the unit.
Power Retry: When enabled, if a camera power fault is detected the unit will retry to connect the
power to that camera
Retry Count: Sets the maximum number of times the unit will retry to power a camera power
output if a fault is detected.
Retry Timeout: Sets the time in seconds between each camera power retry.
Camera Power: Individual enable (tick) or disable of camera power outputs. Colour indicates power
status – green is good, red is fault.
Serial Ports Page
The serial ports page is used to configure the operation of the serial ports of the unit.
There are 5 serial ports available on the unit for use in a variety of ways.
Serial Port: Selects the number of the serial port to be configured
Port Config: Configures the port identified for a particular purpose. The choices available are:
Disabled – the port will not function
•
General Pupose
•
LED Box
•
Radar
•
Telematics
•
GPS
•
CANbus
•
NetVu Ltd. www.netvu.org.uk
No 1 Thellow Heath Park, Northwich Road, Northwich, Cheshire. CW9 6JB
Page 34 of 66.
Advertisement
Table of Contents
