Table of Contents
Advertisement
2.3
Powering the Car DVR On / Off
2.3.1 Auto Power On/Off
When the Car DVR is correctly installed and connected to your vehicle's 12v power supply, the Car DVR will automatically
power up and start recording when the vehicle accessories are activated.
2.3.2 Manual Power On/Off and Reset
2.3.2.1 Manual Power On
Hold the Power
2.3.2.2 Power Off
Make sure that recording has been stopped and then press the Power
powering down the device please wait for 10 seconds before turning the Car DVR back on.
2.3.2.3 Reset the Device
If the Car DVR does not function normally, try restarting the car DVR. To restart the car DVR, with a flattened paper
clip press the small button in the middle of the underside of the Car DVR.
2.4
Playing back video on a PC
To playback video files on your PC it is recommended to connect the Micro SD card (not included) directly to your PC using either
a USB Micro SD card reader (not included) or if your PC has a SD card slot, a Micro SD/SD Card converter (not included). Once
the Micro SD card is connected it should appear as a removable storage device. It is recommended that you transfer video files
that you want to playback to a file on your computer before attempting to playback. This will reduce any delay in playback.
2.5
Initial Settings
Before using the Car DVR we recommend Formatting the Inserted Micro SD Card and setting the correct Time and Date.
2.5.1 Formatting the Inserted Micro SD Card
Formatting the Micro SD card will delete all information on the inserted Micro SD Card and prepare the card for use with
the Car DVR.
1. Press the
(Rec/Ok) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Video Menu .
button on the top of the camera until the NanoCam Plus start up screen appears.
button on the top of the car DVR. After
9
Advertisement
Table of Contents
