Park Mode; Number Plate - NanoCam Plus NCP-DVR720 User Manual

2.8.0 Park Mode

When activated, Park Mode will monitor the DVR's G Sensor after you have turned off your vehicle. If an impact is detected
the DVR will power up and record a 60 second clip. To set Park Mode, follow the instructions below.
1. Ensure that the Car DVR is not recording.
2. Press the
3. Use the
(Rec/Ok) to select.
4. Use the
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. Park mode requires the DVR's internal battery to be fully charged.
3. Park Mode is activated when an impact is detected and will record from that point onward.

2.8.1 Number Plate

Number Plate will stamp your vehicles number plate onto the footage for reference. To set the Number Plate setting
please follow the instructions below.
1. Press the
2. Press the
3. Use the
(Rec/Ok) to select.
4. Select ON and then press the
5. Use the
proceed to the next character.
6. When you have finished inputting your vehicles number plate, use the
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
18 2. For date stamp to be correct the time and date must be set first. To set the time and date please see section Date/Time (3.2.1).
(Menu) Button to enter the Video Menu .
and Buttons to navigate the Settings Menu and highlight the Parking Mode setting and press
and Buttons to highlight either OFF or ON, then press the
(Rec/Ok) Button to stop the Car DVR from recording.
(Menu) Button to enter the Video Menu .
and Buttons to navigate the Settings Menu and highlight the Number Plate setting and press
(Rec/Ok) Button.
and Buttons to select cycle through numbers and letters. The
(Rec/Ok) button to confirm your selection.
(Menu) button is used to confirm and
(Rec/Ok) button to save and exit.