Caution • Ensure you are using your Car DVR within your countries’ road laws. Please make sure you are familiar with your local road legislation before use. • Avoid leaving your Car DVR in direct sunlight for extended periods of time in an unventilated space. •...
1. Introduction Thank you for purchasing a NanoCam Plus Car DVR. We are certain that our product will give you troublefree operation while providing you with a safety feature that enhances your driving experience. Our products, like most after-market safety enhanced devices, are designed to assist and aid the driver, not to replace the manual function of the person operating the vehicle.
2. Getting Started 2.1 Inserting Memory Card With the Car DVR turned off and the screen facing towards you insert the memory card with the text on the Micro SD card facing toward you. Push the memory card in until a click is heard. Note: 1.
2.3.2 Manual Power On/Off and Reset 2.3.2.1 Manual Power On Hold the (Power) button on the top of the camera until the NanoCam Plus start up screen appears. 2.3.2.2 Power Off Make sure that recording has been stopped and then press the (Power) button on the top of the car DVR.
Initial Settings Before using the Car DVR we recommend Formatting the Inserted Micro SD Card and setting the correct Time and Date. 2.5.1 Formatting the Inserted Micro SD Card Formatting the Micro SD card will delete all information on the inserted Micro SD Card and prepare the card for use with the Car DVR.
2.6 Using the Car DVR 2.6.1 Recording Video When the Car DVR is connected to your vehicle's 12v power supply, the Car DVR will automatically power up and begin recording when you start your vehicle. During the start up the buttons will be unresponsive and the camera will take a moment to begin recording.
2.7.2 Loop Recording Loop recording allows you to set the duration that the camera will record before creating a new clip. To set the clip length please follow the instructions below. 1. Press the Button to stop the Car DVR from recording. 2.
2.7.5 G Sensor The G Sensor defines the required force needed to trigger emergency recording. Once Emergency recording is triggered the current recording will be saved and protected from being saved over by the normal loop recording. To set the required sensitivity please follow the instructions below.
2.7.8 Contrast The Contrast setting is used to control the colour contrast of the Car DVR’s photos and videos. To adjust the Contast, please follow the instructions below. 1. Press the Button to stop the Car DVR from recording. 2. Hold the Button for 2 seconds to enter the Settings Menu.
2.8.1 Screen On Switch Screen On Switch is used to set a timer for the screen to turn off after the car DVR has started recording. To adjust the screensaver setting follow the instructions below. 1. Press the Button to stop the Car DVR from recording. 2.
Note: 1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu. 2.8.4 Language The Language setting is used to select your preferred Language in the menus. To set the systems language follow the instructions below.
2.8.7 Timezone The Timezone setting is used to set the time zone that the camera is being used in. To set the time zone please follow the instructions below. 1. Press the Button to stop the Car DVR from recording. 2.
3. Settings Menu Image Quality 1 Minute 5 Minutes Loop recording 3 Minutes Motion Detecton High Parkmode Middle High G Sensor Middle High Volume Middle Contrast Exposure Auto Record 10 Seonds 30 Seconds Screen On Switch 20 Seconds Close Recording Audio Date Set Date ENGLISH...
This warranty is provided in addition to your rights under the Australian & New Zealand Consumer Law. NanoCam Plus warrants that this product is free from defects in material and workmanship for a period of 12 months from the date of purchase or for the period stated on the packaging.