Table of Contents
Advertisement
2.7.8 G Sensor (Gravity Sensing)
The G Sensor defines the required force needed to trigger emergency recording. Once Emergency recording is triggered
the current recording will be saved and protected from being saved over by the normal loop recording. To set the required
sensitivity please follow the instructions below.
1. Press the
(Rec/Ok) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Video Menu .
3. Use the
and
(Rec/Ok) to select.
4. Use the
and
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. If your memory card is filling up quickly you may need to lower the sensitivity of the G Sensor (Gravity Sensor) to decrease the number of triggers
caused by normal driving.
2.7.9 Key Beeps
The key beeps setting mutes the beep button that is emitted when a button on the Car DVR is pressed
1. Press the
(Rec/Ok) Button to stop the Car DVR from recording.
2. Press the
(Menu) Button to enter the Video Menu .
3. Use the
and
Ok) to select.
4. Use the
and
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
Buttons to navigate the Settings Menu and highlight the Gravity Sensing setting and press
Buttons to highlight either OFF or ON, then press the
Buttons to navigate the Settings Menu and highlight the Key Beeps setting and press
Buttons to highlight either OFF or ON, then press the
(Rec/Ok) button to confirm your selection.
(Rec/Ok) button to confirm your selection.
(Rec/
17
Advertisement
Table of Contents
