Table of Contents
Advertisement
2.7.2 Loop Recording
Loop recording allows you to set the duration that the camera will record before creating a new clip. To set the clip length
please follow the instructions below.
OK
1. Press the
Button to stop the Car DVR from recording.
2. Hold the
Button for 2 seconds to enter the Settings Menu.
M
3. Use the
and
select.
4. Use the
and
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2. To avoid filling the card quickly it is advised to use the 2 or 3 minute options.
2.7.3 Motion Detection
Motion Detection is used to pause recording when no motion is detected in front of the camera, and to start recording
when motion is detected again. To activate the Motion Detection setting follow the instructions below.
OK
1. Press the
Button to stop the Car DVR from recording.
2. Hold the
Button for 2 seconds to enter the Settings Menu.
M
3. Use the
and
select.
OK
4. Use the
Buttons to turn OFF and ON Motion Detection indicated by the check box.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
2.7.4 Park Mode
When activated, Park Mode will monitor the DVR's G Sensor after you have turned off your vehicle. If an impact is detected
the DVR will power up and record a 60 second clip. To set Park Mode, follow the instructions below.
OK
1. Press the
Button to stop the Car DVR from recording.
2. Hold the
Button for 2 seconds to enter the Settings Menu.
M
3. Use the
and
OK
4. Use the
Buttons to turn OFF and ON Park Mode indicated by the check box.
Note:
1. Menus cannot be accessed while the camera is recording. Please stop the recording before attempting to access the menu.
Buttons to navigate the Settings Menu and highlight the Loop Recording setting and press
Buttons to highlight your required Clip Length, then press the
Buttons to navigate the Settings Menu and highlight the Motion Detection setting and press
Buttons to navigate the Settings Menu and highlight the Park Mode setting and press
OK
button to confirm your selection.
OK
OK
to
OK
to
to select.
11
Hide quick links:
Advertisement
Table of Contents
