Installation With Mounting Plate; Install Fixing Screws In Parallel To Actuator - Pilz PSEN ml b 1.1 Operating Manual

Installation
2. Use four M5 screws to fix the safety switch to the mounting surface.
8.2.2

Installation with mounting plate

1. Attach the mounting plate to the swing gate/sliding gate.
2. Use four M5 screws to fix the safety switch to the mounting plate.
8.2.3

Install fixing screws in parallel to actuator

Use four M5 screws to fix the safety switch to the mounting surface.
Legend
[1] Safety switch
[2] Actuator
[3] Fixing screws of the safety switch in parallel to the respective actuator
Operating Manual PSEN ml b 1.1/2.1/2.2, PSEN ml DHM
1005444-EN-02
ø 8,5
NOTICE
Correct distances when installing the actuator
The actuator must be attached at the same distance to the mounting sur-
face as the safety switch.
If the safety switch is installed using a mounting plate, then the actuator
must also be installed using a mounting plate (see
mounting plate [ 35]).
[1]
Fixing screws in parallel/side-on to actu-
ator, with mounting plate
Provide the mounting surface with tapped
holes as indicated.
[2]
[3]
PSEN ml DHM
Install actuator on
| 33