Installation Without Mounting Plate - Pilz PSEN ml b 1.1 Operating Manual

Installation
As a result, the safety switch can be installed on the frames of left and right hinged sliding
gates and swing gates. If necessary use a
Accessories [
Different holding forces arise, based on the installation.
– Installation on sliding gates
– Installation on swing gates:
The tapped holes must have a depth of at least 6 mm.
Installation of safety switch
Fixing screws in parallel/side-on to actuator,
no mounting plate
Fixing screws in parallel/side-on to actuator,
with mounting plate
8.2.1

Installation without mounting plate

1. Attach the safety switch to the swing gate/sliding gate.
Operating Manual PSEN ml b 1.1/2.1/2.2, PSEN ml DHM
1005444-EN-02
65]).
Holding force F = 2000 N
Zh
Holding force F in accordance with EN ISO 14119 = 4000 N
1max
Holding force F = 3000 N
Zh
Holding force F in accordance with EN ISO 14119 = 6000 N
1max
31
Mounting plate [ 33]
Tapped hole
Tapped holes for four M5 screws on the
mounting surface.
Tapped holes for two M8 screws on the
mounting surface, for attaching the mount-
ing plate.
Fixing screws in parallel/side-on to actu-
ator, no mounting plate
Provide the mounting surface with tapped
holes as indicated.
(see Order reference:
| 32