Installation Positions For Escape Release; Installation Stationary Escape Release - Pilz PSEN ml b 1.1 Operating Manual

Installation
}
Prevent the effect of transverse forces on the escape release.
}
Secure the screw connections with a medium-strength threadlocker.
}
The button of the escape release pin must be clearly visible and must not be concealed.
}
The mounting surface has to completely cover the bottom of the escape release housing.
The bottom of the escape release housing must not be accessible after installation.
8.4.2

Installation positions for escape release

The stationary escape release can be installed on the three auxiliary releases in three dif-
ferent directions each.
Legend
[1]
[2]
8.4.3

Installation stationary escape release

1. Remove the security screw [1] using a Torx T10 screwdriver T10.
2. Screw the adapter disk of the escape release with the two hexagon sockets M3x8 [3]
on the safety switch with 1,2 - 1,5 Nm (see diagram). The pin of the adapter disk [2]
must be at the place where the security screw of the auxiliary release [1] used to be.
Operating Manual PSEN ml b 1.1/2.1/2.2, PSEN ml DHM
1005444-EN-02
[1]
Installation options at the sides
Installation options at the back
[2]
| 39