Assigning A Community Name - Cabletron Systems SmartSTACK 100 User Manual

Configuring Your ELS100-16TX
To display information about a specific workgroup, at the LCM
prompt:
1. Type
workgroup NAME
To create or modify a workgroup, at the LCM prompt:
1. Type
workgroup NAME PORT-RANGE INFO
To delete a workgroup, at the LCM prompt:
1. Type
workgroup NAME delete
To create or modify the port list for a specific workgroup, at the
LCM prompt:
1. Type
workgroup NAME PORT-RANGE
To display the network classification of a specific workgroup, at
the LCM prompt:
1. Type
workgroup NAME INFO

3.12 ASSIGNING A COMMUNITY NAME

A community name is similar to a password. You use the same
steps to assign a new community name or to change an existing
community name. You can then enter a community name to
perform any
SNMP
you access the device.
To assign a community name, at the LCM prompt:
1. Type
community
2. Enter the old community name.
3. If one has not been assigned,
4. Enter the new community name.
3-18
sets. The default password is public the first time
is the default name.
public