Cabletron Systems SmartSTACK 100 User Manual page 58

Configuring Your ELS100-16TX
The display could look like the following:
ELS100-16 > status 1
Type/Speed:
Port Mirroring:
Duplex Mode:
Bridging:
Enabled/Disabled:
Spanning Tree:
Trunking State:
Pkts Transmitted:
Pkts Received:
Carrier Losses:
Total Collisions:
Excess Collisions:
RX Missed pkts:
RX Runt pkts:
RX FCS/Align Errs:
Internal TX Errs:
Type <CR> to display port 2 status...>
The following conditions can be displayed:
• Broken — Trunking is enabled, but the port in non-operational.
• Closed (or Oneway) — Trunking is enabled, and the Trunking
Protocol is attempting to establish a trunk connection.
• Helddown — Trunking is enabled, but the trunk connection was
rejected. After a short time-out period, another attempt is
automatically initiated to establish a good trunk connection.
• Joined — Trunking is enabled, and the Trunking Protocol has
established a good trunk connection.
• Off — Trunking is not enabled.
3-12
Port 1 Status
10B-TPX/10Mbits
No
Half Duplex
Transparent Bridging
Enabled, Rip listening
Forwarding
Off
1693
0
1693
0
0
0
0
0
0