Switching Off The Id Identicators - Fujitsu PRIMERGY GX2570 M6 Upgrade And Maintenance Manual

▶ Inform the customer about the new or changed MAC address.
Checking the label
▶ If available, check the label on the controller. Beside the part number, you
may find the MAC address.
Using an UEFI BIOS
▶ Enter the BIOS setup menu.
▶ Select the System Information menu.
▶ Under Network Controller Details you will find information of MAC addresses
of each network controller.
The addresses are displayed at the Advanced menu main page.
Or:
▶ Enter the BIOS setup menu.
▶ Select the Advanced menu.
The addresses are displayed at the Advanced menu main page.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
LAN controller provide the MAC addresses independent on Legacy
Boot or UEFI Boot.
For more information see the corresponding BIOS reference manual.
5.2.9

Switching off the ID identicators

The ID indicators can also be deactivated using IPMI.
Using the ID button on the I/O panel
▶ Press the ID button on the I/O panel to switch off the ID indicators.
For more information, see
GX2570 M6
"" on page
Upgrade and Maintenance Manual
Basic software procedures
264.
77