Table of Contents
Advertisement
Enter Setup
Set Scanner Name
You may scan the below barcode to set the name of your scanner. The maximum length is 5 characters (HEX values from 0x20 to
0x7E). The default scanner name is "00000".
If setting the scanner name as "0AB00"：
1.
Scan the Enter Setup barcode
Scan the Scanner Name barcode
2.
Scan the numeric barcode "3" "0" "4" "1" "4" "2" from the "Digit Barcodes" section in Appendix
3.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix
4.
5.
Scan the Exit Setup barcode
Introduction
Every symbology (barcode type) has its own unique attributes. This chapter provides programming barcodes for configuring
the scanner so that it can identify various symbologies. It is recommended to disable those that are rarely used to increase
the efficiency of the scanner.
Global Settings
Enable/Disable All Symbologies
If the Disable All Symbologies feature is enabled, the scanner will not be able to read any non-programming barcodes
except the programming barcodes.
Enable All Symbologies
** Exit Setup
Scanner Name
Chapter 6 Symbologies
66
Advertisement
Table of Contents
