Newland NLS-BS30 User Manual page 45

31
Program the scanner to only read Barcode 1 in the figure above by setting the decoding area
to 10% top, 45% bottom, 15% left and 30% right:
1. Scan the Enter Setup barcode.
2. Scan the Top of Decoding Area
Scan the numeric barcode "0" from the "Digit Barcodes" section in Appendix.
3.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
4.
5. Scan the Bottom of Decoding Area
Scan the numeric barcodes "4" and "5" from the "Digit Barcodes" section in Appendix.
6.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
7.
8. Scan the Top of Decoding Area
Scan the numeric barcodes "1" and "0" from the "Digit Barcodes" section in Appendix.
9.
10. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
11. Scan the Left of Decoding Area
12. Scan the numeric barcode "0" from the "Digit Barcodes" section in Appendix.
13. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
14. Scan the Right of Decoding Area
15. Scan the numeric barcodes "3" and "0" from the "Digit Barcodes" section in Appendix.
16. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
17. Scan the Left of Decoding Area
18. Scan the numeric barcodes "1" and "5" from the "Digit Barcodes" section in Appendix.
19. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
20. Scan the Exit Setup barcode.
barcode.
barcode.
barcode.
barcode.
barcode.
barcode.
Enter Setup
** Exit Setup