Trigger Commands; Modify Start Scanning Command - Newland NLS-BS30 User Manual

Trigger Commands

When Enable Trigger Commands is selected, you can activate and deactivate the scanner in the Level mode with serial
trigger commands. Sending the Start Scanning command (default: <SOH> T <EOT>, user-programmable) to the scanner
in the Level mode activates a decode session. The decode session continues until a barcode is decoded or the decode
session timeout or the scanner receives the Stop Scanning command (default: <SOH> P <EOT>, user- programmable).
** Disable Trigger Commands

Modify Start Scanning Command

The Start Scanning Command can stimulate the trigger unreleased and consist of 1-10 characters (HEX values from 0x01
to 0xFF). In this command, the character "?" (HEX: 0x3F) cannot be the first character. The default Start Scanning
command is <SOH> T <EOT>.
Set the Start Scanning command to "*T":
1.
2.
3.
4.
5.
27
Modify Start Scanning Command
Scan the Enter Setup barcode.
Scan the Modify Start Scanning Command barcode.
Scan the numeric barcodes "2", "A", "5" and "4" from the "Digit Barcodes" section in Appendix.
Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
Scan the Exit Setup barcode.
Enter Setup
Enable Trigger Commands
** Exit Setup