Service Interval Display: Reset - Volkswagen Touareg 2010 Manual

Touareg 2010 ➤
Maintenance - Edition 11.2011
4.40.3 Renewing wiper blade protection, ver‐
sion 3 „transport wiper blade"
– Switch ignition on and off briefly with bonnet closed.
– After switching ignition off, move wiper lever down to touch-
wipe position within 10 seconds.
The wipers move in service position.
– Lift the wiper arm away from windscreen.
– Depending on version, turn wiper blade with lip upwards and
pull off, or release wiper blade at joint -3- by pushing locking
device -1- into mounting -2- and pull wiper blade out.
– Push the standard wiper blade into mounting. Ensure that it
audibly engages into locking device or turn wiper blade with
lip down onto stop.
Caution
When doing this, do not touch the wiper blade to prevent dam‐
age.
– Carefully place wiper arm back onto windscreen.
– Switch ignition on and briefly operate the wiper lever to move
the wipers back to park position. Switch ignition off again.
4.41

Service interval display: Reset

Additional information for service interval display
The service interval display (SID) must be reset during
♦ every delivery inspection (see note)
♦ every oil change service, interval service and inspection serv‐
ice
(adapted)
Note
The „inspection-service reset" test program makes a distinction
between whether resetting is carried out during the delivery in‐
spection or during the inspection service. The time counter is
reset in such a way that either 3 or 2 years, respectively 1095 or
730 days, is set as the maximum value for the next inspection
service. The factory setting fro the first inspection interval is 1095
days. The maximum value for the kilometre counter is always
60,000 km.
4.41.1 Resetting service interval display using
vehicle diagnosis tester
– Connect vehicle diagnosis tester .
– Switch on ignition.
110
4. Descriptions of work
⇒ page 4
⇒ page 15