Service Interval Display - Volkswagen 1993 Golf Instruction Manual

CONTROLS AND EQUIPMENT
1 - Service interval display
The display appears after switching on the
ignition (engine not started) for a few sec­
onds in place of the mileage recorder in
speedometer. If no service is necessary IN
00 will be displayed.
If a service is due, the following appears in
the display for a few seconds even after
starting the engine
•
0 E: L - Engine
oil change
• :n
0 : -
Inspection service
• : n
02 -
I nspection service with addi­
tional work
After a service has been carried out, each
service must be called up individually and
the display zeroed . If for instance the in­
spection service IN 02 with oil change is car­
ried out, the OEL, IN 01 and IN 02 must be
zeroed . The zeroing will be carried out by
the Volkswagen dealer as follows :
• The zeroing of the service interval dis­
play should only be carried out in "total"
mileage recorder mode. If the service inter­
val display is zeroed in the "trip" recorder
mode the trip recorder can be erased .
• With the ignition switched off, press and
hold the button below the speedometer
(left arrow)
• Switch off ignition and release button.
The word OEL can be seen in the display By
briefly pressing the button for adjusting the
analog clock (right arrow) or the minute but­
ton of the digital clock will zero the service.
• By again pressing the button below the
speedometer the other services will be dis­
played and can be cancelled individually
• Switch on ignition.
Notes
• Do not zero the display between the ser­
vice intervals - otherwise an incorrect read­
ing will be shown.
• If the battery is disconnected the details
in the service display are retained.
• If a defective speedometer is replaced,
the service interval display must be repro­
grammed This should be carried out by a
Volkswagen dealer. Should the display not
be reprogrammed , then the service work
must be carried out in accordance with the
Service Schedule and not according to the
service display. The service display only be­
comes valid again after an inspect ion IN 02
is carried out and the service display is
zeroed.
40