Volkswagen Touareg 2010 Manual page 141

– Using the other wires from adapter -VAS 5087/1- make a con‐
nection to the vehicle battery, by connecting:
♦ Red clamp on positive
♦ Black clamp on negative.
Note
When using the engine speed adapter -VAS 5087 A- press
♦
button „Start". The red signal lamp must flash for approx. 10
seconds. Then the green signal lamp must light up.
The engine speed must now be displayed on ignition tester -
♦
V.A.G 1767- .
If the engine speed is displayed incorrectly or not at all ⇒ Op‐
♦
erating instructions for VAS 5087
Test sequence
– Start engine and run at idling speed.
– Press button for „EET diesel" on data reader.
F2
If the following is indicated on display:
Please insert vehicle identity card!!
Manual input with -> button
– Enter vehicle identification data as follows, using data reader
keyboard:
♦ Registration number
♦ Vehicle manufacturer = „NO. 2"
♦ Key number = „to NO. 2"
♦ Vehicle type = „NO. 3"
♦ Key number = „to NO. 3" (the first 3 digits)
♦ For vehicle identification number = „NO. 4"
♦ Engine code
♦ Odometer reading
– Confirm entry of vehicle identification data by pressing
ton.
Check input with -> button
Continue with Q button
– Confirm entry of vehicle identification data with
If the following is indicated on display:
Read bar code
Manual input with the -> button
– Enter specifications using bar code reader of data reader, to
do this slide bar code reader over respective bar code of data
sheet in „Exhaust emissions test" binder.
Or
– Perform entry by hand following instructions on data reader
display by pressing the
If the following is indicated on display:
Check input with the -> button
Continue with the Q button
Q
button.
→
Maintenance - Edition 11.2011
but‐
Q
button.
Touareg 2010 ➤
137
5. Exhaust emissions test