Force Modem To Home State; Stdma State; Transmit Frequency; Transmit Data Rate - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n
Tip: This command is useful when a CDM-570/570L's initial set up is
completed and the unit is functioning as desired in a network.

Force Modem to Home State

If at any time it is desired to have a CDM-570/570L return to its Home State,
this command (enter Y) can be executed. The Home State parameter values are
"forced" into the Base Modem configuration so that they match. The Base
Modem parameters will be updated to reflect any modifications that have been
made from this menu.
A warning message is displayed as shown in figure 3-62, requiring the
command to be confirmed before it is executed.
Figure 3-62
Force Modem to Home State warning

STDMA State

This command (enter T) toggles the setting of STDMA in the target CDM-570/
570L's home state between Enabled and Disabled. This is the same feature that
is set from the Feature Configuration menu screen shown in figure 3-3.

Transmit Frequency

Enter A at the command prompt to use the dialog shown in figure 3-63 to set the
Transmit Frequency for the target CDM-570/570L's home state.
Figure 3-63 Transmit Frequency prompt
Note that this screen dialog example displays the frequency range for the CDM-
570L L-Band modem. For the CDM-570, the range displayed will be either 50
to 90 MHz or 100 to 180 MHz.

Transmit Data Rate

Enter B at the command prompt to use the dialog shown in figure 3-64 to set the
Transmit Data Rate for the target CDM-570/570L's home state.
C h ap t e r U s i n g t h e C o m m a n d L i n e I n t e r f a c e ( C L I )
3 - 3-45