Set The Satellite Modem Configuration; Figure 2-7 Tx Configuration Screen - Comtech EF Data Vipersat CDM-570 User Manual

I n i t i a l C o n f i gu r a t i o n
4.

Set the Satellite Modem Configuration

1.
2.
Figure 2-7
3.
4.
2-10
If this Hub unit is providing the TDM outbound, a route statement or state-
ments defining satellite communications with the Remote units must be
entered as well. One recommended option is to enter a single super-route
that will handle satellite communications with all of the remote subnets; an
example of this is shown as Route002 in figure 2-6, above.
Enter S at the command prompt in figure 2-6 to save the settings to flash.
Enter M from the Main Menu, then enter C from the Satellite Modem
menu to access the Configuration screen.
Enter T to access the Tx Configuration screen shown in figure 2-7. Set
the Tx parameters for Frequency, Data Rate, FEC, Code Rate, and
Modulation as specified by the network administrator.
Note that only Turbo Product Coding is acceptable for FEC when the
CDM-570/570L is running in Vipersat mode.
Tx Configuration screen
Enter R to access the Rx Configuration screen, and set the Rx parameters
as specified by the network administrator.
Save the settings to flash by entering S at the command prompt.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e