Get Information For Router V1.5.3; Figure D-7 Unit Information Screen (Router; Figure D-8 Select Configuration Screen - Comtech EF Data Vipersat CDM-570 User Manual

F i r m w a r e U p g r a d e

Get Information for Router v1.5.3

Figure D-7
The new unit information will show that Image 1 Version=1.5.3 and that the
Application Version=1.5.3. The application CurrentBoot should = the image
slot location of 1.5.3, and NextBoot=Latest and Save=Oldest.
The next part of this step is very important. Prior to version 1.5.3 code, the
configuration files did not include all modem parameters or any Out Door Unit
(ODU) parameters. These parameters are stored in 2 lines in the configuration
file. If they are not saved, the modem will go to the default settings, causing the
BUC and LNB to turn Off. As a result, the Remote will be lost when the modem
firmware is updated.
Select "Configuration" in mode selection and "Get Configuration".
Figure D-8
Save the configuration file. Open it using WordPad. Insure that the lines shown
in figure D-9 are in the configuration near the bottom of the file.
D-8
Unit Information screen (Router)
Select Configuration screen
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e