Auto Switching; Current Wan Transmit Mode; Voice & Video Application Switching; Figure 3-34 Stdma/Scpc Auto Switching Screen - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-34
STDMA/SCPC Auto Switching screen (Remote)

Auto Switching

The Auto Switching item is for information only and shows the current config-
uration of the target CDM-570/570L. This feature is Enabled and Disabled as
described in section "Feature Configuration" on page 3-4. Auto Switching must
be Enabled in order to utilize any of the related features/commands in this
menu.

Current WAN Transmit Mode

The Current WAN Transmit Mode item is for information only and reflects
the current status of the CDM-570/570L. If the CDM-570/570L is functioning
as a Hub in the network, this item will always read Continuous as shown in
figure 3-33. If the CDM-570/570L is functioning as a Remote in the network
and STDMA is enabled on the target CDM-570/570L, this item will show
STDMA (Burst) as shown in figure 3-34.
Tip: This menu item is useful for determining whether a Remote modem is
currently operating in STDMA or SCPC mode.
Voice & Video Application Switching
One of the four automatic switching functions that the Vipersat CDM-570/570L
is able to perform is Application Switching. The Vipersat CDM-570/570L
provides application switching for non-encrypted SIP and/or H.323 traffic that
is detected on the satellite network. When encryption prevents the detection of
this type of traffic, an alternate means of SCPC switching can be configured
using the ToS auto switching feature.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
3-24