Setting Vipersat Cdm-570/570L Operating Parameters; Set The Feature Configuration - Comtech EF Data Vipersat CDM-570 User Manual

I n i t i a l C o n f i gu r a t i o n
Table 2-1
Hub Burst Controller providing STDMA Timing Maps
Hub Point-to-Point SCPC Modem
Hub Switched Demodulator
Remote STDMA Modem
Remote Point-to-Point SCPC Modem
Remote Mesh Demodulator
Setting Vipersat CDM-570/570L Operating
Parameters
The following is an example of using the CLI to bring a Vipersat CDM-570/
570L with factory default settings to the configuration which allows the Viper-
sat functions to be accessible.
When the parameter file (param image) of the CDM-570/570L has either been
reset to or still has the factory default configuration, all Vipersat feature and
unlock codes in the CDM-570/570L are deleted and all configurations are reset,
disabling the Vipersat feature set.

Set the Feature Configuration

The operating parameters that will be configured in the target CDM-570/570L
are, in part, determined by the role the CDM-570/570L is to fill in the network,
as shown in table 2-1 and table 2-2.
Use the following procedure to configure a CDM-570/570L to the network role
it is to fill in a Vipersat network.
1.
2-4
CDM-570/570L Network Roles and Functions
CDM-570/570L Network Role/Function
From the Main Menu shown in figure 2-1, select the Administration
command by entering A at the command prompt.
Hub Remote Expansion
X
X
X
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
X
X
X
X X