Remove Timeout; Remove Retry Timeout; Figure 3-27 View Remote(S) Screen; Figure 3-28 Remove Timeout Prompt - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o nf i g u r a t i o n
Figure 3-27
View Remote(s) screen
The display is for information only and pressing any key will return you to the
menu shown in figure 3-16.

Remove Timeout

Entering R at the command prompt shown in figure 3-16 will display the
Remove Timeout dialog shown in figure 3-28. Note that the menu item shown
in figure 3-16 shows the current setting (in seconds) for this parameter.
Figure 3-28
Remove Timeout prompt
The value entered at the command prompt in figure 3-28 defines the amount of
time (in seconds) with no communication from a Remote to the Hub before that
Remote is removed from the Burstmap. This feature is useful, for example, in an
SNG application where a mobile remote has finished its assignment and has
shut down.
If communications are lost for this period of time, the Remote is removed from
the STDMA group, and the bandwidth resources it had been allocated are then
made available for use by the other remotes remaining in the group.

Remove Retry Timeout

Entering T at the command prompt in figure 3-16 will display the Remove
Retry Timeout dialog shown in figure 3-29.
V i p e r s a t C D M - 5 7 0 / 5 7 0 L U s e r G u i d e
3-20