Stdma Statistics; Figure 3-29 Remove Retry Timeout Prompt; Figure 3-30 Stdma Statistics Screen (Hub) - Comtech EF Data Vipersat CDM-570 User Manual

V i p e r s a t C o n f i g u r a t io n
Figure 3-29
Remove Retry Timeout prompt
When a Remote is removed from the STDMA group, as described in the section
"Remove Timeout" above, entering a value in the Remove Retry Timeout
dialog above defines the amount of time (in seconds) that is allowed to pass
before a retry attempt is made to return the removed Remote to the group.
This allows, again using a mobile remote as an example, shutting down the
remote at one location, moving it to a new location, and then automatically re-
establishing a connection to the satellite network.

STDMA Statistics

Entering V at the command prompt on the STDMA screen displays the
STDMA Statistics as shown in either figure 3-30 (Hub) or figure 3-31
(Remote). These screens provide information for the number of Bursts (Remote
only), number of Burst Maps, and the current STDMA Cycle Length.
Because the Remote modem bursts back to the Hub once every cycle, the
number of Bursts displayed should be a multiple of the number of Burst Maps
displayed, with this multiple determined by the number of cycles per burst map
(1, 2, or more) that has been defined at the Hub. For the example shown in
figure 3-31 (Dynamic Cycle), the number of cycles per burst map is one, and
therefore the number of Bursts equals the number of Burst Maps.
Figure 3-30
STDMA Statistics screen (Hub)
C h ap t e r U s i n g t h e C o m m a n d L i n e I n t e r f a c e ( C L I )
3 - 3-21