Module Group Id - ICP DAS USA I-2533CS-FD User Manual

2.7. Module Group ID

The CAN port with the same "Group ID" setting can communicate with each other
via fiber optics. This setting is used for I-2533CS-FD to communicate with the others
modules on star topology application.
Users can decide the value from 0 to 3 via pin 8 ~ 9 on 10-pin dip switch. The dip
switch for "Group ID" is over the power connector.
I-2533CS-FD ( CAN/CAN FD to Single-mode Fiber Bridge ) User Manual (version 1.1.0)
Copyright © 2020 ICP DAS Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Figure 2-7-1 Location of Group ID DIP Switch
Page: 19