Receiver Configuration - Dish And Bell Tv - King Quest VQ4100 Troubleshooting Manual

4.3
1. Turn on the TV and satellite receiver.
2. Turn on controller and wait for the COAX CONNECTION light to stop flashing and remain on.
Press SCAN.
The antenna will locate all of the appropriate satellites before completing the search process.
After the antenna acquisition process is complete, specific SCAN PROGRESS lights will
turn on to indicate which satellites have been found (see chart on page 18).
If you configured the antenna for DISH HD and SD and the antenna cannot acquire the
110, 119, and 129 satellites, you may need to configure the antenna for DISH HD and
SD Alternate (page 15).
3. On the receiver remote, press MENU, 6, 1, 1.
4. Highlight "Check Switch."
Press SELECT on the remote.
NOTE: Some receivers may prompt you to select
"Check Switch" a second time to initiate
the test.
5. Make sure "SuperDISH" and "Alternate" boxes
are NOT selected.
NOTE: Not all receivers will display a screen with
options that include "SuperDISH" and
"Alternate" boxes.
6. Highlight "Test."
Press SELECT on the remote.
The receiver will perform a check switch test, during which time the antenna will periodically
move back and forth between satellites. This process will take several minutes.
Page 16

Receiver Configuration - DISH and Bell TV

Screen graphics may vary.