Operation - King Quest VQ4100 Troubleshooting Manual

Place the antenna unit in a position with a clear view of
the southern sky to scan for the DIRECTV 101 satellite.
Place the KING Quest on a stable and reasonably level surface with a clear view of the southern sky.
When placing the KING Quest in position, be sure surface is dry and free of loose dirt or sand.
Place power injector in
an accessible location.
Do not over tighten the coax connections.
Do not route the coax cable where it can be tripped on or run over by a vehicle.
Do not put sharp bends or kinks in the coax cable.
When all connections are made, the antenna will scan for the DIRECTV 101 satellite.
When the satellite is found, your programming will appear. Enjoy!
The antenna unit may lock on the satellite in as little as 2 minutes,
The KING Quest is not programmed to lock on the 119 satellite, so you will not receive your local channels if they
are broadcast from the 119. If you wish to receive programming from the 119 as well as the 101, you can replace
the power injector with the KING UC1000 Controller (sold separately - see your dealer or our website
www.kingconnect.com for details).
3.2
Make connections 1-3 in the order shown.
IMPORTANT!
PLEASE BE PATIENT!
but may occasionally take up to 10-15 minutes.

Operation

Do not move antenna unit after
plugging in power supply as the
IMPORTANT!
Any tall objects can block
the signal from reaching
the antenna.
IMPORTANT!
Plug in power supply last.
antenna has begun scanning.
Page 5