Antenna Configuration - King Quest VQ4100 Troubleshooting Manual

TO CHECK THE CURRENTLY PROGRAMMED SERVICE:
1. Press POWER to turn on controller.
• The COAX CONNECTION light will flash for approximately 10 seconds and then remain on.
• SCAN PROGRESS lights will flash 3 times to indicate the selected service configuration.
See chart below to determine currently programmed service indicated by the lights that
flashed.
1. With controller on, press and hold SCAN for five seconds.
The COAX CONNECTION light and the SCAN PROGRESS lights that indicate the currently
selected service will begin flashing.
2. Press SCAN repeatedly to scroll thru the available service options.
3. W hen the correct lights turn on to show the desired satellite configuration, press and hold
SCAN for five seconds to save in memory.
All lights will turn off except for the COAX CONNECTION light.
4. Turn off controller.
4.2

Antenna Configuration

NOTE: The order of the lights corresponds to the order of the satellites listed.
EXAMPLE: DISH SD: Light 1 = satellite 110, Light 3 = satellite 119.
TO PROGRAM A DIFFERENT SERVICE:
Page 15