1. Press POWER to turn on the controller. Wait for the lights to stop flashing and for the COAX
CONNECTION light to remain on.
2. Simultaneously press and hold POWER and SCAN for five seconds. Controller begins beeping.
• Single Beep (beep...beep...beep)
• Double Beep (beep beep...beep beep)
3. Press and release SCAN to toggle between the on and off conditions.
Beep pattern will change to indicate new condition.
4. When alarm is in desired condition, press and hold SCAN for 5 seconds to save in memory.
COAX CONNECTION light will turn solid and SCAN PROGRESS lights will stay off.
5. Press POWER to turn off the controller.
If the coax cable is disconnected from the antenna unit or the controller while the system is turned on or in standby
mode, the controller will sound an audible alarm.
To turn off the alarm when it is sounding, press POWER until the controller turns off.
You can change the alarm condition at anytime by following the steps above.
4.7
Alarm Configuration
Alarm is OFF.
Alarm is ON.
ALARM OPERATION
Page 29