Operation - King Quest VQ4100 Troubleshooting Manual

1. Make sure your TV and receiver are turned on.
2. Press POWER to turn on the controller. Wait for the lights to stop flashing and for the COAX
CONNECTION light to remain on.
3. Press SCAN.
• The antenna will scan for the selected satellites. The four SCAN PROGRESS lights will cycle
on and off to indicate a scan is in progress.
• As satellites are located, the corresponding SCAN PROGRESS lights will turn on (see below).
• When scan is complete, the appropriate lights will be on to show which satellites were found.
• Wait for the program guide to download and then select your desired channel. Enjoy!
Use this chart to determine which satellites have been found.
NOTE: The order of the lights corresponds to the order of the satellites listed.
Example for DISH SD: The 110 satellite corresponds to Light 1, and the 119
satellite corresponds to light 2.
If you move the vehicle, you will have to reacquire the satellites by repeating the scan process. The KING Quest will
go into "sleep mode" after 15 minutes and the COAX CONNECTION light will dim.
To turn the unit off at any time, press POWER for 5 seconds.
Page 18
4.4

Operation