King Quest With Uc1000 Controller - King Quest VQ4100 Troubleshooting Manual

Section 4
If the KING Quest is connected with the UC1000 controller,
use this section. (If connected with a power injector, use section 3.)
The KING Quest can be configured to work with DIRECTV, DISH, or Bell TV (each service requires
paid programming subscription).
Use section 4.2 to verify, or change, the desired service configuration.
DIRECTV:
Choose your desired DIRECTV service option, then go to section 4.4 Operation.
Switch and dish type settings for DIRECTV receivers:
DIRECTV SD
Switch Type: 02:Multiswitch • Dish Type: 01: 18" Round
DIRECTV SD with Locals
Switch Type: 02:Multiswitch • Dish Type: 02: 3-LNB (18 x 20")
DISH:
C hoose your desired DISH service option, then go to section 4.3 receiver configuration.
After performing the check switch test, use the operating instructions in section 4.4.
If you have a DISH model ViP
simplified KING Tailgater user interface on your receiver.
In section 4.2, Antenna Configuration, choose Tailgater Mode.
Turn on your TV, receiver and controller, and then go to section 4.6, Tailgater Mode (skip sections 4.3 and 4.4).
Bell TV:
C hoose your desired Bell service option, then go to section 4.3 receiver configuration.
After performing the check switch test, use the operating instructions in section 4.4.

KING QUEST WITH UC1000 CONTROLLER

Older receivers: choose round dish-1 satellite
Older receivers: choose oval dish-2 satellites
If your receiver does not offer one of these settings,
call KING at (952) 922-6889 ext. 173 for assistance.
The KING Quest will not work with SWM only receivers.
IMPORTANT! DISH CUSTOMERS ONLY!
®
211z, ViP211k, ViP211 or 411 single tuner HD receiver, you can use the
Page 13