Table of Contents
Advertisement
(8), Parity (none), Stop Bits (1).
Click [Add] button to confirm the setting. The connection is saved (and moved to the
table). From that moment the program will enable a remote connection with the
equipment and allows reading and saving the parameters in the equipment's
memory.
Programming through CSD connection is possible also when OSM.2007 system is
installed, with at least one GSM modem connected. If the device is registered for the
server (serial number and SIM card number – see OSM.2007 Manual) you can use the
connection via OSM. Provided that no GPRS connection is established. Programming
attempt (via GPRS connection – see the above) will end with a question whether you
want to use a modem connected to the server. If the answer is yes, the procedure
will continue as in case of other programming channels.
5.3.1.6. File -> Automatic device settings backup
All configuration wizard's settings, both these read from devices and these saved in
the equipment are automatically recorded on a hard drive. If, during configuration
wizard's installation no directories were changed, the files can be found in e.g.:
C:\Program Files\EBS\KonfiguratorLX\configs\CPX200NWB_20000\
CPX200NWB_20000 directory contains all files related to programming the
CPX200NWB type device of the serial number 20000. Files names contain date and
time of the operation and its type (recording/reading). The files are recorded with
.cmi extension.
CPX200NWB ALARM CONTROL UNIT – INSTALLER MANUAL
Serial port to which the GSM modem is connected to (e.g. COM2)
PIN code of SIM card installed in the GSM modem, e.g. 1111
Serial port parameters: Number of bits per second (e.g. 115200), Data Bits
NOTE: Remote configuration via CSD channel is available only in
case the CSD data transfer is active for both SIM card inserted in
the equipment and SIM card installed in GSM modem.
Additionally, the control unit must accept CSD connections – see
item 6.7.1.2. Authorized GSM Modems Numbers.
48 / 118
Advertisement
Table of Contents
