Table of Contents
Advertisement
Examples:
a) change of a single parameter – assigning 1, 2, 3 zones to the first partition:
b) change of a single parameter – assigning 1, 10, 11 zones to the second partition:
c) change of time for leaving both partitions into 60 seconds:
d) change of many parameters at the time for partition 2 using complex function –
zones 2, 4, 5 and output 1 to belong to partition 2, time for leaving the one to be
45 seconds, alarm time in partition 2 to be 120s and signalling of time for entering
and leaving was quiet:
Note:
parameters at the time) after the parameter is entered and confirmed
with
the system waits for entering another parameter, and so on, until all
parameters of the complex service function are entered. Press
cancel changes entered in currently configured parameter only and
exit service function – previously entered parameters, confirmed with
, will not be cancelled.
4.3.9.
Wireless zones configuration
4.3.9.1. Wireless sensors configuration
Wireless zones can be configured using complex service functions, after activation of which,
all the parameters related to the relevant zone can be given subsequently or in a form of
series of service functions that configure one zone-related parameter. Codes of zone
configuration functions are defined as per the following pattern:
Where:
XX –
determines the number of wireless zone from 01 to 16; entering number 00 will
change the parameters for all zones in the system,
Y – number of parameter related to a given zone:
CPX200NWB ALARM CONTROL UNIT – INSTALLER MANUAL
In
case
of
complex
, the parameter is saved in the configuration memory and
<XX> <Y>
(long press)
(long press)
function
(programming
... ...
many
to
31 / 118
Advertisement
Table of Contents
