Table of Contents
Advertisement
9.1.3.6. CPDELUSER
Format:
Limitations:
Description
CPX200NWB ALARM CONTROL UNIT – INSTALLER MANUAL
CPDELUSER=id[,adminPassword]
This command only works when sent through an encrypted way, you must
know the administrator password (the user id == 0), id ranging from 1 to
8 inclusive. The command needs the option"Allow remote user
management" to be set active in the Configurator. Can be executed only
by ATS or administrator. If the command is executed by ATS, specify
adminPassword
Delete the user. Id is the user number, adminPassword is the system
administrator password. The command returns:
CPDELUSER:EOK,id
If the user is deleted
CPDELUSER:ENOT_EXISTS,id
If the specified user does not exist
CPDELUSER:EPERMISIONS,id
If you can not delete a user because the administrator password is
incorrect
CPDELUSER:ENOT_ALLOWED
If the command is sent via open SMS or the configuration does not allow
remote management of users
CPDELUSER:EFORMAT
If the format of the sent command is incorrect
107 / 118
Advertisement
Table of Contents
