Table of Contents
Advertisement
o 1 – signalling alarm,
o 2 – stand-by indicator,
o 3 – power failure,
o 4 – ATS failure – no communication with receiving server.
o 5 – GSM signal jamming indicator
o 6 – chirp on arm/disarm
o 7 – chirp on arm/disarm and signalling alarm
2 – time of output activation in seconds (DEC type parameter); if 0 is set, output will
operate in bi-stable mode.
It is possible to configure the chirp options using following patterns:
chirp signal duration:
a.
b. interval duration between two following chirps:
NOTE: Chirp configuration is common for all outputs
Example:
a) change of a single parameter – operation mode of number 2 output into bi-stable
operation mode:
b) change of 3 output type into triggered by power failure:
c) change of many parameters at the time for output 1 using complex function –
output 1 is to be set as alarm signalling with activation time 120 seconds:
Note:
parameters at the time) after the parameter is entered and confirmed
with
system waits for entering another parameter, and so on, until all
parameters of the complex service function are entered. Press
cancel changes entered in currently configured parameter only and
exit service function – previously entered parameters, confirmed with
, will not be cancelled.
4.3.8.
Partitions configuration
Partition configuration can be configured similarly as zones and outputs, using complex
service functions after activation of which, all the parameters related to the relevant
CPX200NWB ALARM CONTROL UNIT – INSTALLER MANUAL
In
case
of
complex
the parameter is saved in the configuration memory and the
<X>
, where <X> is the time in miliseconds
<X>
, where <X> is the time in miliseconds
function
(programming
many
to
29 / 118
Advertisement
Table of Contents
