Operating Multiple Cameras With The Infrared Remote Controller; Adjusting The Camera - Bolin Technology VCC-2HD10S-SN User Manual

Zooming
Press either of the ZOOM buttons.
Note
When you perform pan/tilt operation while the camera is in the telephoto mode,
the moving speed of the image on the screen may be a little jerky.

Operating Multiple Cameras with the Infrared Remote Controller

1. Set the DIP Switch on the bottom of the camera to the number of camera you
want to operate to 1, 2 or 3.
(See bottom DIP Switch setting instruction)
2. Press the CAMERA SELECT button on the infrared remote controller that
corresponds to the number set in step1.
Then, you can operate the camera(s) specified by number. Every time you operate the camera(s) using the infrared remote
controller, the CAMERA SELECT button pressed in step 2 lights.

Adjusting the Camera

Focusing on a Subject
Focusing the camera on a subject automatically
Press the AUTO button.
The camera focuses on the subject at the center of the screen automatically.
Focusing the camera on a subject manually
After pressing the MANUAL button, press either the FAR or the NEAR button to have the
camera focus on the subject.
Shooting with Backlighting
When you shoot a subject with a light source behind it, the subject becomes dark.
In such a case, press the BACK LIGHT button.
To cancel the function, press the BACK LIGHT button again.
Note
The BACK LIGHT function is effective if MODE is set to FULL AUTO in the
EXPOSURE menu of the camera.
AUTO
23
NEAR
MANUAL
BACKLIGHT