Ip Stream Configuration - ZeeVee ZyPerMX2 User Manual

4. Select either UDP or RTP or RTMP for the stream type from the Transport drop-down list.
(Note that HLS configuration is covered in the next section.)
5. Enter the destination IP address in the Stream IP field. If you enter a valid IP multicast
address (range 224.0.0.0 to 239.255.255.255), any endpoint registered with that multicast
receives the stream. If you enter a valid IP unicast address, only that specific address
receives the IP stream. Important note: The 224.0.0.x range is used for protocol discovery
and are flooded to every port. Because they are reserved and may not be constrained by
IGMP snooping, we recommend against using them. If unicast, only the specifically ad-
dressed endpoint will receive the stream.
6. Enter the port number in the Stream Port field. The supported port range is 1025 to 65534.
The destination IP port must not conflict with other IP protocols. If necessary,
contact the System Administrator for assistance.
7. Click the Apply button to save the changes or click the Reset button to discard any
changes.
TS Type Description
UDP Uses less overhead; lacks packet acknowledgement or error
correction.
RTP Protocol built on top of UDP; delivers real-time multimedia and
detects out of sequence packtets
RTMP Protocol commonly used by Content Delivery Networks such as
Wowza and Youtube Live.
7
Basic Operation