Recovering A Lost Password - ZeeVee ZyPerMX2 User Manual

The ZyPerMX4/MX2 does not provide any built-in safeguards for lost or forgotten
passwords.
The ZyPerMX4/MX2 must be reset to factory-default settings using the NAV / Control
button on the front panel. Use the admin password to login and then change the password
under the Device tab.
1. Locate the NAV / Control button on the front of the unit. This is both a button and
wheel.
2. Disconnect power from the ZyPerMX4/MX2. While applying power, rotate dial to the
Left to reset the ZyPerMX4/MX2 to factory defaults. Rotate dial to the Right to revert
the ZyPerMX4/MX2 to previously installed version of firmware. Be sure to hold the
dial either Right or Left until reboot begins.
3. The unit will reboot and after about 60 seconds, the unit will be ready for use.
4. Follow the steps under
Note: All IP streaming customization settings will be lost as a result of a factory reset.

Recovering a Lost Password

Setting the Password (page 25)
26
Basic Operation
to complete the process.