Rebooting The Zypermx4 - ZeeVee ZyPerMX2 User Manual

► Using the Reset Button/Wheel (NAV / Control)
1. Locate the NAV / Control button on the front of the unit. This is both a button and
wheel.
2. Disconnect power from the ZyPerMX4/MX2. While applying power, rotate dial to the
Left to reset the ZyPerMX4/MX2 to factory defaults. Rotate dial to the Right to revert
the ZyPerMX4/MX2 to previously installed version of firmware. Be sure to hold the
dial either Right or Left until reboot begins.
3. The unit will reboot and after about 60 seconds, the unit will be ready for use.
The ZyPerMX4/MX2 can be rebooted using Maestro. All configuration settings are saved
through
reboots.
1. Login to the Maestro web interface. See Logging In (page 3) for more information.
2. Click the Device tab.
3. Click the Reboot button, under Actions.
4. Confirm the Reboot action to initiate the reboot.
Rebooting the ZyPerMX4/MX2
24
Basic Operation