Sliders; Extruder; Sostituzione Protezione Ooze Shield - Wasp Delta 4070 Industrial X Series Manual Of Use And Maintenance

7
Ordinary and extraordinary maintanance
7
P
remises
If they are, provide for their replacement.

7.2.5. Sliders

Check plays
Check that the arm sliders do not have any play between them and the sliding aisle, if it is present, contact the
manufacturer

7.2.6. Extruder

Cleaning
In the event that the extruder is clogged, it is possible to clean it using the appropriate cleaning kit.
To clean the extruder consult the material present on the website www.3dwasp.com or for additional information
contact support@3dwasp.com

7.2.7. Sostituzione protezione Ooze shield

The Ooze shield protection is present only in the Zen extruder, therefore the procedure does not exist in the
other types of extruder.
To replace the Ooze shield, deform it by allowing it to be removed by the six screws underneath the extruder.
To assemble the new protection, widen it by hooking the holes provided on the six screws under the extruder.
The protection can be cleaned to continue using it or be replaced with a new one in the event of breakage.
fig 7.2.6 a fig 7.2.6 b
Fig. 7.3.1- Removal of Spitfire extruder
© WASP S.r.l.
41