First Start - Wasp Delta 4070 Industrial X Series Manual Of Use And Maintenance

5.3. First start

After having correctly connected the printer to the socket it is necessary to perform some operations in order to
allow the printer to work.
Belt-stop clamps
Inside the printer there are three belts necessary for moving the extruder during printing.
To avoid movements of the extruder during transport, clamps are applied on the straps, to be removed before
starting the printer.
Filament removal from extruder
ATTENTION:
Pay particular attention during the various stages of the procedures, it is essential to wear gloves
as there is a risk of burns.
To remove the filament, proceed as follows:
1. Turn on the printer by activating the on / off button.
2. From the display select the "PRINT" item and in the next menu select the "LOAD filament" item.
3. Follow the procedure on the display
© WASP S.r.l.
Description of the printer
P
remises
5
5
33