Ordinary and extraordinary maintanance
P
remises
7.2.8. Print bed cleaning
The bed is cleaned with the machine switched off. It is necessary in cases of:
•
Flatness compromised
•
Dirt that prevents adhesion during printing
•
Aesthetic necessity
To carry out this operation it is necessary to remove the top by unscrewing the three screws indicated in figure
7.2. Once removed, clean with water and detergents as needed. It is not recommended to use metal parts that
could damage the surface and abrasive machines that could compromise the flatness.
42
Fig. 7.2.8 - Screws for the removal of the bed
Fig. 7.2.1 - Holes for the replacement of the air filters
© WASP S.r.l.