Interface Board (Optional); Parts For Installation (Optional); Projected Image And Throw Distance - Panasonic PT-RQ22KD Operating Instructions (Functional Manual)

Interface Board (optional)

This projector is equipped with two SLOT NX-specification slots.
There are four SDI input terminals and one DIGITAL LINK input terminal equipped on this projector as the
standard video input terminals. The input for HDMI, DVI-D, and SDI can be added by installing the optional
Interface Board in the slot.
Attention
f Requesting a qualified technician to install or remove the optional Interface Board is recommended. A malfunction may occur due to static
electricity. Consult your dealer.

Parts for installation (optional)

When installing the projector on a ceiling, the optional Ceiling Mount Bracket is required. The Ceiling Mount
Bracket (Model No.: ET-PKD520H (for High Ceilings), ET-PKD520S (for Low Ceilings)) is used together with the
Ceiling Mount Bracket (Model No.: ET-PKD520B (Projector Mount Bracket)).
Model No.: ET-PKD520H (for High Ceilings), ET-PKD520S (for Low Ceilings), ET-PKD520B (Projector
Mount Bracket)
f Be sure to use the Ceiling Mount Bracket specified for this projector.
f Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.
Two projectors can be used stacked on top of each other by using the optional Frame (Model No.: ET-PFD510).
Attention
f To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualified
technician.

Projected image and throw distance

Install the projector referring to the projected image size, projection distance, etc. Image size and image
position can be adjusted in accordance with the screen size and screen position. When the Fixed-focus Lens
(Model No.: ET-D75LE95, ET-D75LE90) or the Fisheye Lens (Model No.: ET-D3LEF70) is used, the projection
relation between the screen and the projector differs from that of other lenses. For details, refer to "Fixed-focus
Lens (Model No.: ET-D75LE95, ET-D75LE90)" (x page 44), "Fisheye Lens (Model No.: ET-D3LEF70)"
(x page 45).
Attention
f Before setting up, read "Precautions for use" (x page 20).
Especially when the Fixed-focus Lens (Model No.: ET-D75LE95, ET-D75LE90) is used, install the projector so that its back plane is parallel
to the screen, making the projected image rectangular.
The vertical keystone distortion in moderate range can be corrected with the [POSITION] menu → [GEOMETRY] → [KEYSTONE] →
[VERTICAL KEYSTONE] (x page 110) even after the projector is installed. For the range that can be corrected, refer to "[GEOMETRY]
projection range" (x page 47).
f The geometric adjustment function cannot be used when the video signal in simultaneous format is input. When installing the projector,
follow the instructions below so that distortion does not occur in the projected image.
g Use a flat screen.
g Install the projector so that the front side of the projector is parallel to the screen.
g Install the projector so that the image can be projected within the lens shift adjustment range.
f Do not use the projector and the high-powered laser equipment in the same room. The DLP chips can be damaged if a laser beam hits the
projection lens surface.
42 - ENGLISH
Chapter 2 Getting Started — Setting up